shopsrefa.blogg.se - Old tractor pulls

#OLD TRACTOR PULLS MANUALS#
#OLD TRACTOR PULLS REGISTRATION#

Both loaded tires and any amount of wheel weights at events with scales. Either loaded tires or three sets of wheel weights, not both events with no scales.

Three sets maximum at events with no scales. This means any factory cast rear wheel weights bolted securely in the stock location. Two sets maximum at events with no scales. This means any factory front cast wheel weights bolted securely in the stock location. This means any factory cast frame weights bolted in the stock location.

All tractors must be equipped with safety bars strong enough to support the weight of the tractor when tested by a judge.

Safety pads must be stationary and must not be less than 25 square inches per pad.

All safety bars must be equipped with safety pads on the ends of the bars.

Three-point hitch arms may be used, if bolted stationary into position.

Safety bars must be rigid and stationary and extend 4 inches past the rear tires and 10 inches from the ground.

The safety bars must be made out of three-inch channel iron or the equivalent.

All tractors must be equipped with safety bars.

Tractors in the 8500, 9500, 10,500, and 11,500 classes will be limited to maximum tire width of 18.4 inches on row crop style.

Tractors in the 6500, 7500, pound classes will be limited to a maximum tire width of 16.9 inches.Tractors in the 2500, 3500, 45 pound classes will be limited to a maximum tire width of 15.5 inches.Industrial tractors that cannot meet this requirement must remain stock.

#OLD TRACTOR PULLS MANUALS#

Unusual stock items: The owner of any tractor equipped with unusual or seldom seen parts will be required to bring parts, operators or service manuals to verify to officials that the parts are factory stock.Tractors with 2 or 3 point hitch drawbar must have drawbar secured with stabilizer bars or pins.The minimum distance from the centerline of the rear axle to the pin hole where the clevis is attached is 24 inches.The clevis must be attached to the drawbar in the normal location.Washers may be used to shim the clevis.This will be measured from the point of contact that hook on the chain will have with the tractor. The maximum hitch height is 18 inches.a clevis is to be used and cannot be modified.

#OLD TRACTOR PULLS REGISTRATION#

Registration at 8 am, pull begins at 9 am.